You are currently viewing How To Test A Relay Without A Multimeter

How To Test A Relay Without A Multimeter

How To Test A Relay Without A Multimeter. 1.) find the relay that has to be tested and turn it on. Use a digital multimeter (dmm) to test the resistance between each pole of the relay and the corresponding nc and no contacts for that pole.

How To Test A Relay The Drive
How To Test A Relay The Drive from www.thedrive.com

Luckily, fuel pump relays are easy to test and replace on your own. To check the coil’s resistance with a multimeter, take a multimeter and put it on the ohmmeter setting then connect the multimeter probes on any two terminals of relay’s coil. First, pull the fuse from the concerned circuit.

The Relay Will Engage With Clicking Sound.

Once the voltage is present, you should set the multimeter to continuity mode and assess the 86th slot if it has an excellent connection to the ground. Grab a multimeter and set it to ohms. Control circuit shows resistance 50 to 120 ohms 86 power in example.

With The Relay Removed From The Fuse Box, The Multimeter Set To Measure Dc Voltage And The Switch In The Cab Activated, First Check To See If There Are 12 Volts At The 85 Position In The Fuse Box Where The Relay Plugs In.

All nc contacts should read infinite resistance to the corresponding pole. You can still test the fuel pump relay without a multimeter. The only tool required to check a relay is a multimeter.

Relays Statuses Are Only Tested Using A Multimeter.

That being said, set the multimeter to the resistance setting. The relay should click and youll have continuity. Check the energized condition of the relay contacts.

Here Is How You Test A Car Relay The Correct Way.

A multimeter — to determine if the relay has resistance, you must use a multimeter. How to test a relay without multimeter? Check through the plastic whether the fuse wire is broken or not.

Testing Continuity Without A Multimeter.

If you can’t see the wire through the plastic, then it’s time to check the fuse with the help of a multimeter. To start, we’ll test the coil of the relay. The purpose of testing a relay is to find, whether it is good or bad.

Leave a Reply